![]() > psi w/ 1/2 lb increments) anytime I am doing > on my tanks w/ a digital pressure gauge( 0-100 ![]() > gave any thought to the dirt aspect though, Good ![]() > bring my feeder into the same location, I never > spirovents(1/2" tapping) for a long time without Sound about right to you(and everyone else)? You have some valid points w/ regard to the dirt.Thanks for the lesson. Also is it an IAS or an EAS that you use? What is an IAS? The only time I use an EAS(B&G enhanced air separator)is if I leave a steel tank in the ceiling at which point I'll install a tank fitting as well and pipe off the 3/4" tapping that the EAS affords me up to the tank. I've yet to have a dirt related problem and some have been in for 10+ years. To get around the pressure issue when removing the tank, I install a butterfly stop and waste valve that relieves the pressure, without a fuss, between the tank and the system. I pull and check pressure on my tanks w/ a digital pressure gauge( 0-100 psi w/ 1/2 lb increments) anytime I am doing service on the jobs and pump 'em up if I have to. Its something I'll definately have to consider in the future. I also bring my feeder into the same location, I never gave any thought to the dirt aspect though, Good point. I have been hanging them from my spirovents(1/2" tapping) for a long time without any negative results (that I know of).
0 Comments
Leave a Reply. |